1. Remove the handle of the lever of gear shifting and the central console

2. Remove the lower air branch pipe and turn off lever arm nuts if it is necessary.

3. Lift the car and install it on support.

2.4a Elements of the mechanism of gear shifting of the Cordia/Tredia models with the mechanical transmission 1. Gear shifting lever 2. Cover 3. Insulator 4. Support 5. Dustproof cover 6. Rubber isolation 7. Lengthening draft 8. Plug 9. Dustproof cover 10. Wire 11. Adjusting screw 12. The switching draft

2.4b Elements of the mechanism of gear shifting of the Colt, Lancer, Mirage and Precis models with the mechanical transmission 1. Handle 2. Gear shifting lever 3. Cover 4. Insulator 5. Plug 6. Rubber insulator 7. Dustproof cover 8. Lengthening draft 9. Plug 10. Adjusting screw 11. The switching draft 12. Wire 13. Dustproof cover

4. Turn off a bolt and disconnect lengthening draft from the transmission (2.4a and 2.4b).

5. Remove  a delay  from  the adjusting  screw, turn off the screw and turn off the switching draft from the transmission

6 Remove the heat-shielding screen if it is necessary

7 Remove the lengthening and switching draft

8. Installation is carried out upside-down removals.

2.9a Elements of the trosikovy mechanism of gear shifting of the Colt, Lancer, Mirage and Precis models 1. Switching lever handle transfers 2. Shelf of the central console 3. Back console 4. Central console 5. Fastening 6. The switching rope 7. Transfer choice rope 8. Gear shifting lever

9. Remove the handle of the lever of gear shifting and the central console. Check that the lever of gear shifting and levers on the transmission were in the provision of neutral transfer. Get checks and clips and disconnect ropes from levers (2.9a and 2.9b).

2.9b Elements of the trosikovy mechanism of gear shifting of the Galant model

10. Turn off bolts and nuts and remove fastenings of ropes.

11. In a motive compartment get checks and clips and disconnect ropes from the transmission.

12. Remove ropes.

2.13a Elements of fastening of a rope to the gear shifting lever - the lever B has to be in the family way of neutral transfer 1 The switching rope 2. Transfer choice rope 3. Slanted party plug 4. Lever B

2.13b Adjust rope length, rotating nuts 1. Adjusting nuts

13. Connect ropes to the lever (2.13a and 2.13b), having checked that it was in the provision of neutral transfer.

14. Connect ropes to the transmission and establish fastenings.

2.15 Distance And yes In on both parties of the lever of gear shifting have to be identical

15. After installation the distance And yes In on both sides lever of gear shifting has to be identical (2.15). If is not present, adjust rope length