03bf454c

7.9. The ignition distributor - removal and installation

Removal
1. Disconnect a wire of the minus plug of the accumulator.
2. Disconnect a wire of high voltage of the coil from a distributor cover.
3. Disconnect vacuum hoses from the ignition advancing module.
4. Mark an arrangement of a wire of high voltage of the first cylinder on a cover of the distributor and uncover.

8.5 Before removal of the distributor mark the provision of a tip of the runner on the distributor case


5. Turn a bent shaft of the engine so that the runner became opposite to the plug of a wire of the first cylinder, and mark position of the runner on the case of the distributor (8.5).
6. Make adjusting marks in the case of the distributor and the block of cylinders. Turn off a fixing nut and remove the distributor. Attention: Do not rotate a bent shaft when to remove the distributor from the engine.
7. Disconnect wires of primary winding of the coil of ignition from the distributor.
Installation
8.  Install the distributor on the block the cylinder, having combined the marks made earlier. Slightly put the fixing clamp and connect wires.
9. Establish a cover of the distributor and connect vacuum hoses to the ignition advancing module.
10. Connect wires of high voltage to spark plugs.
11. Connect a wire of the minus plug of the accumulator.
12. Check a corner of an advancing of ignition and reliably tighten a fixing nut of the distributor.