03bf454c

7.11. Igniter - replacement


12:7á Elements of the distributor of the Cordia and Tredia 2.0L models (1984 and 1985), Galant (1985 and 1986), Colt, Lancer, Miraqe 1.5L (1985-1988) and Precis (1987-1989)
1. Plug of an air vent
2. Cover
3. Piece of coal
4. Rotor
5. Plait of wires
6. Wire of "weight"
7. Igniter
8. Pin
9. Alarm rotor
10. Plate of the centrifugal regulator
11.  The vacuum proofreader  (with two diaphragms)
12.  The vacuum proofreader (with one diaphragm)
13. Rotor axis
14. Fastenings of springs
15. Springs of the centrifugal regulator
16. Small weights of the centrifugal regulator
17. Distributor axis
18. Epiploon
19. Consolidation
20. Case
21. Sealing ring
22. Washer
23. The conducted gear wheel
24. Pin



12:7í Elements of the distributor of the Cordia and Tredia 2.0L (1986-1988) models

1 Cover
2 Rotor
3 Casing of the generator of signals
4 Reception coil
5. Plate of the centrifugal regulator
6. Igniter
7. Igniter casing
8. Vacuum proofreader
9. Consolidation
10. Axis of an alarm rotor
11. Cap
12. Springs of the centrifugal regulator
13. Small weights of the centrifugal regulator


12:7ó Elements of the distributor of the Cordia and Tredia 1.8L Turbo (1986-1988) and Colt, Lancer models,
Mirage 1.6L (1986-1988)
1. Plug of an air vent
2. Cover
3. Piece of coal
4. Rotor
5. Casing
6. Sealing ring
7. Cutting lock ring
8. Vacuum proofreader
9. Screw
10. Screw
11. Alarm rotor
12. Screw
13. Reception coil
14. Stator
15. Rotor axis
16. Pin
17. Fastening of springs
18. Springs of the centrifugal regulator
19. Small weights of the centrifugal regulator
20. Pin
21. The conducted gear wheel
22. Sealing ring
23. Axis
24. Epiploon
25. Case


12:7ú Elements of the distributor of the Cordia and Tredia 1.8L Turbo (1984-1985) and Colt, Lancer, Miracie 1.6LM9851 models

1. Plug of an air vent
2. Cover 3 Piece of coal 4. Rotor
5 Springs of the centrifugal regulator
6. Plate of the centrifugal regulator
7. Small weights of the centrifugal regulator
8. Basis of the centrifugal regulator
9. Alarm rotor 10 Reception coil 1 7. Igniter
12 Breaker
13 Plate
14. Washer
15. Axis
16. Bearing
17. Epiploon
18. Case
19. Sealing ring
20. Pin
21. The conducted gear wheel
22. Vacuum proofreader


1. You watch drawings 12.7a, 12.7b, 12.7v and 12.7g).
2. At installation of igniter do not erase the carrying-out lubricant.
3. Adjust an air gap before installation of the distributor.