5.5. A radiator - removal and installation

Attention! Wait until the engine does not cool down.
1. Disconnect a wire of the minus plug of the accumulator.
2. Merge cooling liquid.
3. Unfasten collars from hoses, then disconnect radiator hoses from branch pipes. If they look strongly worn-out, they should be replaced.
4. Disconnect a hose from a jellied mouth of a radiator.

4.5 To disconnect an engine fan wire, press a pad (it is specified by an arrow).

5. Disconnect the socket of connection  of the fan of cooling (4.5).
6. If on the car the automatic transmission is installed, disconnect cooling system tubes from a radiator.
7. Not to allow liquid leak, it is necessary to cork all branch pipes.
8. Disconnect a hose of the channel of an air inlet and the air cleaner if they are established.

4.9 Turn off bolts, the fixing arms and insulators to a radiator, (the Galant engine of 2,0 l is shown)

9. Unscrew the assembly bolts fixing a radiator. (4.9)
10. Accurately remove a radiator.
11. Examine a radiator on existence of traces of leaks and damages. At their detection the radiator should be replaced.
12. Clear a radiator of dirt and dead insects.
13. Installation is carried out upside-down removals.
14.  Fill in cooling liquid in the cooling system.
15. Start the motor and check system for existence of traces of leaks.
When the engine gets warm up to the normal temperature, double-check the level of cooling liquid.
16. If on the car the automatic transmission is installed, check the level of liquid and add as required.