03bf454c

14:11. The panel of finishing of a door - removal and installation

1. Disconnect a wire of the minus plug of the accumulator.

11:2á On some models the screw of fastening of the handle of a door can be turned off, having pulled the handle on itself



2. Twist fixing screws of the panel of finishing and remove handles (11.2a and 11.2b).

11:2í Fixing screws of the panel of finishing of a door are often closed by casings which can be removed by means of the screw-driver



11:3í On other models remove a clip by means of the screw-driver



11:3á On some models disconnect a handle clip by means of a rag



11. Stars Establish a clip back into place and install the handle on an axis



3. Remove the window regulator handle (11.3a, 11.3b and 11. Stars) or remove and disconnect the window regulator switch.
4. Insert a knife with a wide edge or thin ломик between the panel of finishing and a door and disconnect all fixing latches.
5. Then turn off the lock handle, remove the panel of finishing and disconnect all wires.

11.6 Be accurate at removal of plastic foil - do not tear it



6. For receiving access to an internal part of a door unbend a protective film, trying not to tear it (11.6).
7. Before installation of the panel of finishing, establish into place all fixing latches.
8. Connect all wires and install the panel on a door. Twirl fixing screws and install handles.