1. Turn off a nut of fastening of a nave to a half shaft.

2. Lift the car and remove a wheel. Remove a support of a brake and suspend it on a wire piece.

4.3 Turn off two nuts and bolts fixing a rotary pin to a rack (are specified by shooters) - beat out bolts if it is necessary

3. Turn off, but do not remove the bolts and nuts fixing a rotary pin to a rack of a suspension bracket (4.3).

4. Disconnect a tip of steering draft from a rotary pin.

5. Disconnect the spherical hinge from a rotary pin. Remove the bolts and nuts fixing a pin to a suspension bracket rack.

6. Remove a rotary pin and a nave from the car. Suspend the end of a half shaft on a wire.

7. Establish a rotary pin and a nave into place and insert a half shaft into a nave.

8. Establish a rotary pin on a nave rack, establish fixing bolts and nuts, but do not tighten them up to the end yet.

9. Insert a shaft of the spherical hinge into an opening of a rotary pin and acquire a fixing nut.

10. Connect a tip of steering draft. Tighten all bolts and nuts till the required inhaling moment.

11. Establish a brake support.

12. Establish a nut of fastening of a nave to a half shaft and reliably twirl it.

13. Establish a wheel and lower the car on the earth.

14. Tighten a nut of fastening of a nave to a half shaft till the required inhaling moment.