1. Disconnect a wire of the minus plug of the accumulator.

16:2á On some models turn off the screws fixing the panel of a sound signal to a steering column (the Galant model is shown)

16:2í Raise bottom edge of the panel of a sound signal, then remove it

2. Remove the panel of a sound signal from a steering wheel. On some models the panel fastens screws (16.2a and 16.2b).

16.3 Having turned off a nut of fastening of a steering wheel, make adjusting marks on a shaft of a steering column and a nave of a steering wheel

3. Turn off a fixing nut of a steering wheel and mark the provision of installation of a wheel on a shaft (16.3).

16.4 Use a special stripper for removal of a steering wheel from a shaft of a steering column - you do not knock on a shaft, trying to remove a steering wheel

4. By means of a stripper of a steering wheel remove a steering wheel (16.4).

5. At installation of a wheel combine marks in a wheel and to a shaft. Establish a fixing nut and tighten it till the required inhaling moment.

6. Install the panel of a sound signal.

7. Connect a wire of the minus plug of the accumulator.