03bf454c

11.8. The working cylinder of the drive of switching off of coupling - removal, a partition and installation

1. Disconnect a tube from the cylinder and close its end
2. Remove a fork pin.
3. Turn off fixing bolts and remove the cylinder
4. Squeeze out the piston from the cylinder by means of compressed air.
5. Clear cylinder walls.
6. Examine walls on existence of scratches or wear tracks and replace the cylinder if it is necessary.

7.7 Elements of the working cylinder of the drive of switching off of coupling
1. Cap
2 Spring
3. Pusher
4. Cover
5. Piston and cap
6. Conic spring
7. Cap
8. Valve of production of air
9. Cylinder


7. If the cylinder needs to be replaced, disassemble it completely (7.7).

7.8 Check that the cap was established correctly
1. Piston     
2. Cap


8. At assembly of elements of the cylinder grease them with pure brake fluid. Pay attention to the provision of installation of a spring and a cap (7.8).
9. Installation is carried out upside-down removals.