03bf454c

10.6. A rope of the lever of the selector of the automatic transmission - removal, installation and adjustment

Removal
1. Disconnect a wire of the minus plug of the accumulator

5.2 The rope of the selector fastens to the lever on the transmission with the help checks and washers and to an arm by means of a clip or two nuts (located on each side an arm)


2. In  a motive  compartment  remove  the air filter, disconnect a rope from the lever on the transmission and remove it from an arm (5.2)
3. Lift the car and install it on support
4. From below the car turn off fixing bolts and nuts of a rope

5.5a Elements of the selector of the automatic transmission of the Cordia/Tredia models, and also Colt, Lancer, Mirage and Precis of early years of release

1 Fixing screw 2 Handle
3 The console (is not shown)
4 Bulb
5 Selector panel
6 Bolt
7 Adjusting nuts of a rope
8 Fixing "bolt
9 Nuts of a fixing arm of a rope
10 Fixing nuts of the lever of the selector
11 Selector mechanism
12 Laying
13 Rope
14 Selector lever


5.5b Elements of the selector of the automatic transmission of the Colt, Lancer, Mirage and Precis models of late years of release

1. Shelf of the console
2. Back console
3. Forward console
4. Selector
5. Rope



5.5v Elements of the selector of the automatic transmission of the Colt, Lancer, Mirage and Precis models of late years of release

1. I will corrode connections of the switch of the raising transfer
2. Handle
3. Casing
4. Button
5. Spring
6. The switch  of the raising transfer
7. Bulb
8. Selector panel
9. Plug
10. Spring pin
11. Rod
12. Lower spring
13. Pin
14. Spring
15. Fastening
16. Steel ball
17. Lever
18. Plugs
19. Arm


5.5g Elements of the selector of the automatic transmission of the Galant model of early years of release

1. Button
2. Screw
3. Casing
4. Handle
5. Plug
6. Rod
7. Lever selector
8. Plug
9. Clip
10. Adjusting nut
11. Regulator
12. Plug
13. Rope
14. Rope tip
15. Panel
16. Index
17. Selector panel
18. Bulb
19. Arm


5.5d Elements of the selector of the automatic transmission of the Galant 1987 and 1988 models of years of release

1. Internal box
2. Cap
3. Back console
4. Left casing
5 Right casing
6. Finishing panel
7. Forward console
8. I will corrode connections of the switch of the raising transfer
9. Screw
10. Screw of fastening of the handle
11. Button
12. Spring
13. Handle
14. Casing
15. Selector panel
16. Index
17. Socket of connection of a bulb
18. Lower selector panel
19. Cutting lock ring
20. Pin
21. Air filter
22. Rope winding
23. Clip
24. Check
25. Plug
26. Rope
27. Adjusting nut
28. Regulator
29. Selector lever


5.5e Elements of the selector of the automatic transmission of the Galant model of 1989 of release later

1 Selector panel
2 Switch of an operating mode of the transmission
3 Side casing
4 Side panel of the emergency brake
5 Console
6 Selector lever
7 Clip
8 Fixing clip
9 Clip
10 Fixing clip
11 Rope
12 Plug


5.5zh Elements of the selector of the automatic transmission of the Galant model of 1989 of release later
1 Socket of connection of the switch
2 Casing
3 Handle
4 Button
5 The switch of the raising transfer
6 Pin
7 Button
8 Spring
9 Selector panel
10 Index
11 Lower selector panel
12 Nest
13 Plug
14 Selector lever
15 Plug
16 Arm


5. Turn off fixing bolts and nuts of the lever of the selector (5.5a, 5.5b, 5.5v, 5.5g, 5.5d, 5.5e and 5.5zh)
6. In salon remove the handle of the lever of the selector and the console Disconnect a rope from the lever and remove the selector lever (5.5a, 5.5b, 5.5v, 5.5g, 5.5d, 5.5e and 5.5zh)
7. Remove a selector rope from the car
Installation
8 Installation is carried out upside-down removals
Adjustment
9 Transfer the selector lever to the provision of neutral transfer

5.10 Turn the selector lever for receiving the required gap (A), the slanted party (V) of the plug has to be turned to the driver
1 Plug
2 Lever


10 Having tightened up the plug, adjust a gap between the plug and the lever (5.10)
11. Install the console and the handle of the lever of the selector.
12. Eliminate sagging of a rope, having put the adjusting clamps on the transmission lever (5.5a, 5.5b, 5.5v, 5.5g, 5.5d, 5.5e and 5.5zh).
13. Check operation of the mechanism of the selector. Adjust the blocking switch if it is necessary.