03bf454c

10.4. Replacement of epiploons

1. For replacement of an epiploon of a half shaft lift the car and establish it on support.
2. Remove half shafts.

3.3 Insert a tip of the big screw-driver (it is specified by an arrow) behind an epiploon and accurately get it


3. By means of the big screw-driver accurately get an epiploon from a nest of the transmission (3.3).

3.4 Apply a thin film of lubricant on an external edge of a new epiploon and accurately establish it in a nest by means of a big head and the hammer


4. Apply a thin film of lubricant on an external edge of a new epiploon and accurately establish it in a nest by means of a big head and the hammer (3.4).
5. Establish half shafts. Be accurate not to damage an edge of a new epiploon.
6. If the sealing ring of a gear wheel of the drive of a speedometer proceeds, disconnect a speedometer rope from the transmission.
7. Turn off a fixing bolt and remove the speedometer drive.


3.8 Speedometer drive elements
1. Sealing ring
2. Spring pin
3. Gear wheel
4. Sealing ring
5. Plug


8. Beat out a spring pin and get a gear wheel from the plug (3.8).

3.9 At installation of a gear wheel in the plug check that the spring pin was established by a section from a gear wheel axis


9. Establish new sealing rings on the conducted gear wheel, collect the drive and establish a new spring pin (3.9).
10. Install the drive on the transmission and connect a speedometer rope.